Dealscount Logo
milwaukee connector injection projects robotics
American Nigels 3D Printing LLC

Adapter for Milwaukee M18 Battery Made in USA Connector Dock Holder Mount Injection Molded with Wago's for DIY Projects Robotics

Amazon Price as of 04/04/2025 07:30 GMT+00:00

$15.98

Deal Detector and Price History

We analyze price history to spot good deals

Include Prime Price

Bad Deal

average price $15.81

$0.17 higher than average

$15.98 now

$15.61

$15.86

Price History

Product Description

Adapters Proudly Made in the USA. Adapters are made of glass reinforced nylon 6 (PA6-GF30) which is the same material the drills are made out of. Adapters have 6 countersunk bolt/screw holes for mounting on walls, vehicles, etc…, bolts/screws not included. Adapter has 2 6.3 mm brass male spade connectors over molded into the adapter that are connected to wagos. Terminals are 20 gauge yellow brass which is 70 percent copper 30 percent zinc the wagos are 2 wire 221s. Adapters have pluses and minuses on both sides of them indicating the positive and negative terminals. Adapter is based on my best selling 3d printed model but this is 5x stronger, and can be used outdoors. DISCLAIMER THESE UNITS DON'T HAVE ANY PROTECTION CIRCUITS IN THEM, USE AT YOUR OWN RISK. The following bullet points are directions on how to use this injection molded Milwaukee M18 battery Adapter. The first thing you want to do is strip 10 mm off your wires and plug them into the wagos. The next step is to mount the adapter where you want it, the holes are for M4, #8, or other flat head screws. Run your preferred wire (silicone, pvc, pe, nylon etc...) and preferred gauge (12, 14, 16 etc...) to your circuit. Additional helpful Information You can connect most batteries in parallel and/or series if the batteries are exactly the same. If you don't want to over discharge your battery use a digital low voltage protector disconnect If you want a higher voltage like 24, 36, 48, or 60 volts use a dc to dc step up boost converter If you want a lower voltage like 5 or 12 volts use a dc to dc buck converter

• Adapter slides on your battery easily and locks on just like a drill would • Adapter gives you access to the electrical terminals for electrical projects • Adapters are Injection Molded with Nylon 6 Reinforced with glass fibers. • These adapters are Heavy duty and can be used indoors and outdoors • The mold, stamp, brass terminals, and adapters were made in the USA