
SDR Receiver, 50kHz‑2GHz DSP Full Band Receiver for FM Long Medium Short, 3.5 Inch Touchscreen Shortwave Radio Receiver, SSB NFM WFM Analog Modulation
Amazon Price as of 04/16/2025 07:36 GMT+00:00
$221.72
Deal Detector and Price History
We analyze price history to spot good deals

Include Prime Price
Bad Deal
average price $208.34
$13.38 higher than average
$170.07
$206.34
Product Description
Spec:
Item Type: SDR Receiver
Material: Aluminum Alloy
Frequency Range: 50kHz-2.0GHz (with registration code)
Demodulation Modes: , LSB, NFM, WFM, SAM-U, SAM-L
Chip: For MSI001
For STM32H743 Clock Frequency: 480MHz
: 3.5 Inch IPS Display Screen
Control: 2 encoders with buttons and 1
Current Consumption During Earphone Listening: 300mA
Power Supply: Powered by external TYPE C (for Huawei phone) interface and can be charged through TYPE C. 1 x 3.7V 2500mAh lithium battery (built in battery)
Function:
The built in receiving module has improved the high frequency reception of the antenna, and an additional board with a source follower has been developed. This board will be built into the standard receiver design.
By connecting to the computer via USB, it is possible to transfer CAT, IQ, and audio.
160kHz span, with scalability.
Up to 250MHz, Sensitivity is 0.3μV=10dB at s/w.
Due to the characteristics of the for MSI001 chip used, the dynamic blocking range is about 85dB.
Backlight Control.
antenna socket.
1. HARD(Setting): EN1, EN2: the direction of addition and subtraction of the two encoders is opposite. V Battery Power Display: S standard, L low voltage. SW pre and short antenna selection: 50ohm 50ohm/Hi-z High impedance. ATT attenuator: same as transceiver. LNA MIX, MIX GR: Do not open the current machine (including the original) does not have the function, otherwise the gain and sensitivity will be greatly reduced! RF GAIN and RF Gain: The same as the transceiver, the sensitivity is best when set at about 20. PREAMP: same as transceiver. F Correction and Frequency Correction: Use as needed. correction /S meter correction: Use as needed.
PackageList:
1 x SDR Receiver
1 x Antenna
1 x Data Cable
1 x Interface
• DEMODULATION MODE: The full band radio receiver is based on the principle, and its function is determined by the loaded software. SSB NFM WFM analog modulation is used, and the chip is used, the dynamic blocking range is about 85dB.
• FREQUENCY RANGE: The frequency range is 50kHz to 250MHz and 400MHz to 2GHz (registered upgrade version). Press the frequency knob to switch to step mode, and then use the frequency knob to adjust. The maximum step is 30KHz, and the clock frequency is 480MHz.
• HIGH SENSITIVITY: Built in variable filter width, adaptive noise suppressor, threshold noise suppressor, noise canceller AGC equalizer, high sensitivity. Do not turn on functions that are not available, otherwise the gain and sensitivity will significantly decrease.
• POWER SUPPLY: The shortwave receiver is powered by an external TYPE C interface, with a built in 2500mAh battery, and USB connection to the computer, it can transmit CAT, IQ, and audio, and adopts 3.5 inch IPS , which is sensitive and
• NOISE SHIELDING: Adopting double layer shielding (shell and shielding layer) coverage, it has better noise shielding effect, built in receiving module has been developed to improve the reception of the antenna, and additional board with a source follower has been added.
Reviews
Review AI Summary