Dealscount Logo
wsdmavis switch digital controller protection
WSDMAVIS

WSDMAVIS 1Pcs Delay Relay Switch DC 5V 12V 24V Digital LED Cycle Timer Relay Module Turn On/Off Delay Timer Switch Timing Controller with Case Protection

Amazon Price as of 05/28/2025 01:22 GMT+00:00

$8.69

Deal Detector and Price History

We analyze price history to spot good deals

Include Prime Price

Bad Deal

average price $8.45

$0.24 higher than average

$8.69 now

$8.16

$8.52

Product Description

Operating Mode: P1: trigger signal, the relay is on "OP" time, and then disconnect; in the "OP" time, as follows: P1.1: signal is triggered again, invalid P1.2: signal is triggered again, the clocking is reset P1.3: Signal is trigger again reset, relay off, and stop the clocking; P-2: trigger signal, the relay off "CL" of time, the relay on "OP" time, and then disconnect relay after clocking; P3.1: trigger signal, the relay is turned on after the "OP" time, the relay off "CL" time, then the operation cycles; if trigger signal again during the cycle, the relay off, stop clocking; the number of cycles times ( "LOP ") can be set. P3.2: without triggering signal after power on, the relay is on "OP" time, the relay off "CL" time, then the operation cycles; the number of cycles times ( "LOP ") can be set. P-4: signal holding function. If there is trigger signal, clocking is reset, the relay remains on; when the signal disappears, after clocking "OP" time, the relay is off; if another signal is triggered during clocking, clocking will be reset. How to Set Clocking Range: After setting the parameter value at mode selection, press "STOP" button to set the clocking range; XXX. The last decimal point lights up, range: 1 second to 999 seconds. XX. X The second last decimal point lights up, range: 0.1 seconds to 99.9 seconds X. X. X. all 3 decimal points light up, range: 1 minute to 999 minutes. For example, if you want to set "OP" as 3.2 seconds, light up the second last decimal point, and set digit display as 03.2.

• Dual-MOS in parallel active output, lower inner resistance, larger current, strong power; at room temperature, operating current is up to 15A, power up to 400W, that can be used for most equipment • Wide voltage input from 5V to 36V, normally used for controlling DC motors, lights, LED strips, micro-pumps, solenoid valves, etc.High voltage level trigger (3.0V~24V), signal ground and system ground are not on common ground to improve the system's anti-jamming capability (you can also connect them on common ground) • 0.1 seconds (min) to 999 minutes (max) continuously adjustable.To achieve fast high frequency turn-on and off circuit, an unlimited number of switching times.No noise was made during turning on/off, no spark, and no electromagnetic interference • The emergency stop function (“STOP” key);With reverse polarity protection, reverse polarity will not burn the product.Increase the sleep mode, if this mode is enabled, without any operation within 5 minutes, then automatically turn off the monitor, any key wake-up;You can set a different OP, CL, LOP parameters, which are independent of each other, and are automatically saved;After the module is powered down, all parameter settings are not lost • Note:The module is an active output, the output voltage equal to the input voltage.'DC + 'and' load + 'This is an internal short circuit of the poles, but' DC- 'and' load - 'poles during use can not be shorted, otherwise the load can not be controlled on and off, which is equivalent load is been carrying electricity

Reviews

Review AI Summary

🔥 Top
deals you shouldn’t miss!